Published on: March 2026 2026
LIN BUS FORMULATION USING OPTICAL FIBER
Vivek P Kude Shubhangi B Patil
Article Status
Available Documents
Abstract
The maximum automotives may use the various types of sensors in new advanced vehicles for as per the consumer’s requirements. These sensors may connect using local interface network (LIN). The sensor interfacing of the network is carrying out using copper wired connections for every automobile. The copper wired connections may take time latency for signal transmission, also it generates electromagnetic immunity and cross talk, in emergency case this may give obstruct to user. In the direction of to reduce and avoid such instances, in our work we proposed local interface network using optical fiber. As previously researchers proved that optical fiber have very minute electromagnetic immunity and cross talk also it has high speed signal data transmission capacity as compared with copper wired connections. On the given basis we have observed results which shows that LIN massage transfer rate using optical fiber is 19.2 Mbps whereas using wire it is 19.2 Kbps. The LIN massage stack period using wire is 19.2 milli seconds and using optical fiber it is 19.2 micro seconds.
How to Cite this Paper
Kude, V. P. & Patil, S. B. (2026). LIN BUS Formulation using Optical Fiber. International Journal of Creative and Open Research in Engineering and Management, <i>02</i>(03). https://doi.org/10.55041/ijcope.v2i3.105
Kude, Vivek, and Shubhangi Patil. "LIN BUS Formulation using Optical Fiber." International Journal of Creative and Open Research in Engineering and Management, vol. 02, no. 03, 2026, pp. . doi:https://doi.org/10.55041/ijcope.v2i3.105.
Kude, Vivek, and Shubhangi Patil. "LIN BUS Formulation using Optical Fiber." International Journal of Creative and Open Research in Engineering and Management 02, no. 03 (2026). https://doi.org/https://doi.org/10.55041/ijcope.v2i3.105.
References
[1]. R. J-Michel, M. Steyaert "An EMI Resisting LIN Driver in 0.35-micron High-Voltage CMOS" IEEE Journal of Solid-State Circuits, vol. 42-7 pp. 1574-1685, July 2007.[2]. J.G. Janschitz et al. "An EMI robust LIN driver with low electromagnetic emission", Electromagnetic Compatibility of Integrated Circuits (EMC Compo) 2015 10th International Workshop, 2015, pp. 2145-2153.
[3]. J. P. Dsouz, R. Reddy, S. Yellampalli,“ Diagnostic protocol stack on LIN interface”, IJERT, Vol. 3-11, pp 1208-1211, 2014.
[4]. W. J. Dally, “Performance analysis K-ary n-cube Interconnection networks”, IEEE transaction on computer, Vol. 39-6, pp. 775-785, 1990.
[5]. C. P. Kruskal, M. Snir, A. Weiss, “The distribution of waiting times in clocked multistage interconnection network”, IEEE transaction on computers”, Vol. 37-11, pp 1337-1352, 1988.
[6]. J. P. Patel “Performance of processor memory interconnections for multiprocessors”, IEEE transaction of comters, C-30-10, pp 771-780, 1981.
[7]. A. C. Stanca , F. Sandu, “ Solution to improve the features of local interconnected networks” Bulletin of Transilvania university engineering sciences, vol. 6-55 (2), pp. 97-105, 2013.
[8]. R. Hegde, S. Kumar, K. S. Gurumurthy, “The impact of network topologies on performance of the in-vehicle network”, International journal of computer theory and engineering, Vol. 5-3, pp. 405-410, 2013.
[9]. C. Gabiel, H. Horia, “Integrating sensor devices in LIN bus network”, 26th International spring seminar on electronics technology, pp. 150-153, 2003.
[10]. Y. Sun, “Optimal scheduling algorithm in vehicular real time system” Journal of Network, Vol. 9-3, pp. 785-792, 2014.
Ethical Compliance & Review Process
- •All submissions are screened under plagiarism detection.
- •Review follows editorial policy.
- •Authors retain copyright.
- •Peer Review Type: Double-Blind Peer Review
- •Published on: Mar 22 2026
This article is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. You are free to share and adapt this work for non-commercial purposes with proper attribution.

